Lots of damage to the printer
1. dead or just light the flame alone, can be derived from the power supply or from boardnya.
1.1 if it defective power supply can be sure there will be no lights that glow at all.
1.2.1 if the damaged board, check or replace the bios or her prom.
bios or prom uses an easily removable sockets.
1.2.2 check path (garis2 in board) to the IC box E01A09BB Proms
1.2.3 replace ic E01A09BB
2. do not print as orders
2.1 LPT socket under mechanical checks usually have a loose solder
2.2 under mechanical check printer cable that connects to a socket LPT boardnya
2.3 feet instead of eight ic ic 93C46
2.4 instead of 14 feet ic ic 74LS05
3. do not print the full / empty line in the middle there is writing
3.1 check head, count the number of needles should be nine
3.2 check the spool head, the resistance per spool 35ohm. there are nine spool head
3.3 check that nancap flexible cable in the head
3.4 check transistors on board, there are 9 rows, which is important in avo meter does not indicate the number 0
3.5 check the path to a transistor socket flexible cable
3.6 check the path to a flexible cable socket ic E01A09BB through 751 ohm resistance
